efficient slag remover

The main raw material of slag remover is volcanic ash minerals, the main component is silicate, after special processing and mixing, mainly used for slag removal and heat preservation for the molten steel in the casting process.

efficient-slag-remover

 

There are more advantage of the slag remover, Huatuo has in this for more than 10 years, following will share more experience for the method and advantages of it:

1.Deslagging. The efficient slag remover can be used in ladle,tundish,electric furnace, spread it evenly on the surface of the melt by hand or spray gun, and with a little agitation,it can quickly aggregate into a slag that is easily separated from the metal solution, then remove the slag can get the pure solution. It can avoid casting slag and improve quality.

2.Insulation Cover. It has low thermal conductivity for the slag remover, it can form a good thermal insulation layer on the surface of the molten metal, then can reduce the heat loss of the solution, it is a good thermal insulation covering agent for metal solutions that need to be parked for a long time.

3.Environment Protection. There is no pollution, no penetration to metal melt, no influence on its chemical composition and casting mechanical properties, it will no smoke,dust and harmful gas pollution during use, will not pollute the environment.

4.Dosage. Generally speaking, it will need 1-3kg per ton of metal solution, and it can be increased or reduce according to the size of the melt area, the temperature, and the impurity content of the smelted metal.

There exit different size of the slag remover such as 18-30mesh, 30-50mesh, 50-80mesh,the ability to adsorb slag with coarse particle size is strong, while the ability to adsorb slag with fine particle size is relatively weak; on the same molten steel temperature, the coarse is not good for slagging, fine is good for slagging, generally, the particle size is selected according to the temperature of the molten steel. If the temperature of the molten steel is high, the coarse particle size is used, if the temperature of the molten steel is low, the fine particle size can be selected. Generally speaking, for the precision casting medium frequency furnace and cupola molten iron, the molten steel temperature is about 1600 degrees, so can choose the slag remover of 18-30mesh, for the cast iron molten iron, the temperature is 1300-1400 degree, you can choose the 50-80mesh.

As a trusted supplier of slag remover, Anyang Huatuo own rich experience of the products and export for more than 10 years, we know the raw materials for steelmaking and foundry well, so if any require or confused, welcome for consult.